Download Print this page

Pacer S Series Assembly Instructions Manual

Self-priming centrifugal pumps

Hide thumbs

ASSEMBLY INSTRUCTIONS

for

'S' Series Self-Priming

Centrifugal Pumps

Table of Contents

Need help?

Do you have a question about the S Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Pacer S Series

Page 1 ASSEMBLY INSTRUCTIONS 'S' Series Self-Priming Centrifugal Pumps...
Page 2 ASSEMBLY INSTRUCTIONS for 'S' Series Self-Priming Centrifugal Pumps REFER TO PAGES 5/6 OF THE PUMP OPERATOR'S MANUAL FOR EXPLODED VIEW PARTS DIAGRAM AND PARTS LIST. The impeller (Ref. #15) is normally supplied with the mechanical seal (Ref. #14) installed. If you are installing the seal into the impeller, follow these steps: Lightly lubricate the sides of the impeller seal seat with liquid vegetable oil.
Page 3 Procedures: CAUTION: To prevent accidental starting, remove the spark plug wire from the plug. Drain oil and fuel from engine before standing engine on recoil starter. 1) Stand engine on the recoil starter with shaft up and bottom of the engine towards the person assembling the pump (Fig.
Page 4 6) If bracket screw plugs (Ref. #12) are provided, press them into the hole over each bracket screw. The hole in the plug should face up (Fig. 8). Used only on pumps designed for non-metallic solution contact. Fig. 8 Fig. 9 7) Lubricate the seal ring of your impeller with vegetable oil.
Page 5 8) Use the ﬁ ne threaded ¾"/19mm screw (Ref. #16) to fasten the impeller to the shaft (Fig. 12) Check that a small o-ring is under the screw head (Ref. #8). Tighten the screw as much as possible by hand with a large, ﬂ at head, wide blade screw- driver or 7/16"...
Page 6 12) Place the pump body (Ref. #42) onto the bracket so the discharge opening (large hole on side of body) is toward the bracket handle (Fig. #16). Install the ten body screws (Ref. #21). You will need a 3/8" socket or ﬂ at head screwdriver for the screw head.
Page 7 Pump to Pedestal Assembly Procedures A. For pumps assembled to molded plastic pedestal assemblies (Ref. #55/56). 1. If utilizing the plastic shaft sleeve (Ref. #46) follow procedure #2 found on page 3 of this assembly manual. (If the sleeve is not preapplied at the factory.