Default Setup; Basic Operation - Qtone DA-1001 User Manual

Unit Overview

Default Setup

When initially turned on the amplifier will be setup to default settings. All the input names are
listed as Input 1-3 and Front Panel (relating to the rear input numbering and the 3.5mm jack on
the front of the unit). The tone, balance controls and input pre-amp levels are all set to mid
positions.

Basic Operation

Press the Power button to turn on the unit. When the unit is turned on the LCD display will show
the last selected input source as well as the current volume level. In this mode the source and
volume can be changed.
Select Inputs
Press the corresponding Input Selector button for the source required. LCD will change to
display the current source number and name.
1:INPUT 1
VOL [----------]
Changing Volume
Rotate the Volume/Multi-Control to select the desired volume level, the display will update the
bar-graph to the current level.
2:INPUT 2
VOL [----------]
Muting Volume
Press the Multi-Control knob to mute the audio. The display will flash between the current
volume level and saying MUTE. Press the Multi-Control knob to un-mute. You can also turn the
Multi-Control knob. Turning clockwise will turn the audio up from zero. Turning counter-
clockwise will reduce the volume from the last setting.
2:INPUT 2
VOL [##--------]
User Guide - DA-1001
1:INPUT 1
VOL [----------]
Press Input 2
Turn Multi-
Control
Press Multi-
Control
2:INPUT 2
VOL [----------]
2:INPUT
VOL [##--------]
2:INPUT 2
VOL [---MUTE---]
2:INPUT 2
VOL [##--------]
9