Summary of Contents for Rapido CONFORT
- Page 1 10/06/2010 Rapido Confort Folding Caravan | RAPIDO CONFORT FOLDING CARAVAN ERECTION INSTRUCTIONS FOR RAPIDO CONFORT AND EXPORT MODELS …webs.com/erectioninstructions.htm 1/22...
- Page 2 10/06/2010 Rapido Confort Folding Caravan | Before removing your Rapido from the car, lower the jockey wheel. Push your Rapido to where you want to site it. Keep in mind that the opening side is at the opposite side to the foot lever.
- Page 3 10/06/2010 Rapido Confort Folding Caravan | Lower the right hand jack using the wheel brace supplied, until the jack makes contact with the ground. Swing out the support arms as far as they will go …webs.com/erectioninstructions.htm 3/22...
- Page 4 10/06/2010 Rapido Confort Folding Caravan | Lower the side folding jacks and place onto wooden supports. Lower the screws until they make contact with the wooden supports. Unclip the body catches and fold down. Pull out the foot lever. …webs.com/erectioninstructions.htm...
- Page 5 10/06/2010 Rapido Confort Folding Caravan | Place your foot on the lever and press down using your body weight as a cantilever. Two people can then easily open the body out. …webs.com/erectioninstructions.htm 5/22...
- Page 6 10/06/2010 Rapido Confort Folding Caravan | Rest the body on the supports ( ensure that they are still extended fully and level ). Hold the roof with one hand by the exterior edge. It does not matter which half you open out first, except it is important that the first half opened is against the wind.
- Page 7 10/06/2010 Rapido Confort Folding Caravan | Lift the roof section, then, with the free hand raise the rear section. Note when erecting the exportmatic this is the heaviest part that you will have to lift and will definitely require two people.
- Page 8 10/06/2010 Rapido Confort Folding Caravan | With arms stretched, hold the roof in place, guide the side panel raising it upright. Starting from the bottom, guide it into the groove of the end panel and roof. Ensure that the base of the end panel fits into the groove without force.
- Page 9 10/06/2010 Rapido Confort Folding Caravan | Erect the first half facing the wind so that the second half is protected as it is put into place. The erection of the second half is identical to the first. Use security cords in high winds anchoring them between roof and the base.
- Page 10 10/06/2010 Rapido Confort Folding Caravan | Align the two roof sections by turning the jockey wheel up or down. To fit the security panel in place bring it in from the outside and lock in place with the two bolts.
- Page 11 10/06/2010 Rapido Confort Folding Caravan | Pull down the lower roof making sure that it is located correctly and clip together. To align the roofs, side panels and awning rails, turn the handle of the jockey wheel up or down.
- Page 12 10/06/2010 Rapido Confort Folding Caravan | On the confortmatic the panel door goes in place last but before the furniture. When folding down the panel door is taken out before the roof and security panels are dismantled. On the exportmatic the fold down sections on the stable doors must be folded up before lowering the side sections.
- Page 13 10/06/2010 Rapido Confort Folding Caravan | When erecting the confortmatic on your own, hold the roof with one hand outstretched. Raise the side panels one by one and erect the same way as when erecting it by two people. Now that the caravan is erected you need to fit the shaped support for the two inner walls for the exportmatic.
- Page 14 10/06/2010 Rapido Confort Folding Caravan | Next the bench seat, the kitchen units and wardrobe. The mattresses for the lounge area are kept in the lockers ( confortmatic ) and lockers and wardrobe toilet area for the exportmatic …webs.com/erectioninstructions.htm 14/22...
- Page 15 10/06/2010 Rapido Confort Folding Caravan | Fit the kitchen units in place, once in place it cannot move. Connect water pump, gas supply and waste tank. On the confortmatic it is possible to remove the panel door without moving the kitchen unit.
- Page 16 10/06/2010 Rapido Confort Folding Caravan | When packing down place the mattresses as shown in diagram above. Make sure that nothing is above the level of the hinge on the front panel. To put the wardrobe in place in the confortmatic ,lift it up, pivot into horizontal position and then push bolt to the bottom of the slot.
- Page 17 10/06/2010 Rapido Confort Folding Caravan | On the confortmatic it is possible to open the two roof sections in hot climes as picture. Check first that the four corner buttons are firmly in place. Two people are required one inside and one out.
- Page 18 10/06/2010 Rapido Confort Folding Caravan | To fit an awning feed it into the roof rails from the center and then down both sides. Assemble the frame and position in place inside the awning. …webs.com/erectioninstructions.htm 18/22...
- Page 19 10/06/2010 Rapido Confort Folding Caravan | Zip the side panels and front section into place and fit the awning skirt in place round the base of caravan. To open the panoramic front panel on the confortmatic release the two corner buttons. Release the rail from the inside by pressing down the four spring clips.
- Page 20 10/06/2010 Rapido Confort Folding Caravan | To shut the panoramic panel it must be in perfect alignment to the trailer body. Close the panel and the four clamps should click firmly into place. The confortmatic can be moved when erected .
- Page 21 10/06/2010 Rapido Confort Folding Caravan | Position of the storage wheels for storing the caravan on its side. It is possible to increase ventilation in dry weather by opening the roof gap. Place an empty box of matches or something of that size between the two roof parts.
- Page 22 10/06/2010 Rapido Confort Folding Caravan | Sliding Door Wardrobes Designed & Installed 10yr Guarantee Superb Value - Spring Sale Now On! www.sim plyslidingwa rdrobe s.co.uk Northwest Hardware ltd Locksmiths and DG Repairs In Warrington and Surrounding Area www.northwesthardwa re.co.uk / Patio Awnings - only £68...
Need help?
Do you have a question about the CONFORT and is the answer not in the manual?
Questions and answers