IMPORTANT
PMS
072C
Do not attempt to use the power supply/charger with any other product; do not attempt to operate this product with any other
power supply/charger.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND SAVE FOR FUTURE REFERENCE
Component list
1. Rechargeable toothbrush
Connecting
The charging unit can be connected to voltage outlet
w
between 220-240 volts using a shaver socket outlet or
adaptor socket BS1363/3.
Place the rechargeable toothbrush handle onto the
w
charging base (switch to the front).
The green indicator will light up when the toothbrush is
w
inserted on the plugged-in charging base.
Preserving the rechargeable batteries
To maximise the capacity and life of the rechargeable
w
batteries, they should be fully charged for 16 hours
before the first use, fully discharged in use then
recharged to full capacity again.
How to use
After the toothbrush handle has been fully charged,
w
attach the brush head to the handle by placing it on the
unit twisted slightly to the left and turning to the right
until it is locked into position. To remove, simply reverse
the procedure. The brush head must face the same
direction as the switch.
Wet the brush head and place the toothpaste on the
w
head. Switch the toothbrush on AFTER guiding the brush
head into your mouth.
During the first few days of using, your gums may bleed slightly, particularly if they normally tend to do so. After a few days,
the bleeding will generally stop. If your gums continue to bleed after 2 weeks, you should see your dentist.
Brush heads should be replaced every 2 to 3 months depending upon use. If the bristles splay before 2 months this means that
you are exerting too much pressure on your teeth and gums.
IMPORTANT – Cleaning instructions
The following care instructions must be followed to ensure your toothbrush functions correctly:
1. After use rinse the brush head thoroughly for several seconds
with the toothbrush switched on under running water.
2. Wipe away and remove all toothpaste residue from the
head and handle after use as hardened toothpaste
can lead to damage of the internal mechanism.
Protecting the environment
This marking indicates that this product should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. Disposal can take place at
appropriate collection points provided in your country.
PRO CLEAN
2. 2 x toothbrush heads
Rechargeable
Electric
Toothbrush
3. Portable charging station
The toothbrush may warm up slightly during recharging.
w
This does not effect the operation of the unit.
Over charging is impossible.
To maintain the toothbrush's full performance, it should
w
always be stored on the charging base after use.
This discharging/charging procedure should be done
w
every 6 months.
Position the brush in an angled position and slowly move
w
the brush along the outside and the inside surfaces of all
your teeth and gums. Clean the rear sides and chewing
surfaces of the molars with a rotary movement.
The toothbrush will run for 2 minutes, as per the
w
recommended brushing time by dental professionals.
At exactly 2 minutes the motor will simply turn itself off.
3. Dry handle.
4. Store toothbrush on charging base.
4. Wall mounting fixtures
1
Need help?
Do you have a question about the POWER+ PRO CLEAN and is the answer not in the manual?
Questions and answers