ABB TPS44 Series Operation Manual page 62

Operation Manual / TPS44-F.. - TPS61-F..
5 Maintenance / 5.4 Cleaning components mechanically
5.4.4 Turbine-end, non-rotating parts
© Copyright 2020 . All rights reserved.
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or
contact with them may be harmful to health.
Do not breathe in these substances and avoid contact with the skin.
u
Ensure proper ventilation.
u
Observe the information in the material safety data sheet for the op-
u
erating materials and supplies.
Wear personal protective equipment (PPE) according to the material
u
safety data sheet.
Comply with local legislation.
u
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
Baked-on layers of contamination, for example from heavy fuel oil or
coked oil, occur at the turbine end. The following performance-relevant
parts can be cleaned according to the following description.
51000 Turbine casing
52400 Gas outlet flange
Place contaminated parts in hot water or in a liquid such as brake
u
cleaner, so that the contamination softens.
Brush off the contamination or remove it with a steam cleaner.
u
Repeat the soaking and brushing if necessary.
u
Completely remove any solvents from the parts in clean water.
u
Dry components completely.
u
Spray cleaned surfaces with penetrating oil. Do not spray the outer
u
surfaces of the turbocharger.
Dispose of contaminated water and cleaning agent in accordance
u
with the specifications in the safety data sheet.
HZTL2412_EN
56001 Nozzle ring
Rev.G March 2020