SORINEX OFF-GRID RACK Install Instructions

OFF-GRID RACK INSTALL INSTRUCTIONS
Your rack will arrive in 2 individually wrapped packages. Carefully remove protective wrapping. This is a 2 person installation.
EACH UPRIGHT MUST BE BOLTED TO THE WALL. EACH UPRIGHT MUST BE BOLTED TO THE GROUND. ALL NECESSARY
HARDWARE IS NOT INCLUDED.

HARDWARE / MATERIALS REQUIRED (NOT INCLUDED)

• (12) 3/8" Lag Screws with Washers
• (3) 2x6" (or larger) Wood Support Boards
• General Wood Screws
• (2) 1/2" Concrete Anchor

TOOLS REQUIRED (NOT INCLUDED)

• Tape Measure
• Level (Magnetic Recommended)
• Stud Finder
• Electric Drill or Driver
• Socket Wrench
• 9/16" Socket
• Marker / Pen / Pencil
STEP 1: Install (3) 2x6" (or larger) wood support boards
across your wall perpendicular to the ground using
general wood screws at these specific heights:
• 11.5" on center (Bottom Support Board)
• 49.5" on center (Middle Support Board)
• 87.5" on center (Top Support Board)

STEP 2: While person 2 holds one Off Grid Rack upright,

vertically level, and flush against wood support boards/
ground, mark pilot holes on your wood support boards
using a marker/pen/pencil.
2020 | SORINEX.COM | 1 of 2