Supervised And Non-Supervised Input Wiring - Honeywell MPA2 Installation Manual

The used ferrite has a high impedance (>= 200) in the range of 50 to 250
Mhz. Make sure similar ferrite characteristics is used in your installation for
CE emission compliancy.

2.2 Supervised and Non-Supervised Input Wiring

The supervised inputs are located on the following terminal blocks:
Table 1 Supervised Input Terminal Blocks/RJ45
Board Configuration
Main Board Rdr/Door1
connector
Main Board Rdr/Door2
connector
Main Board
Additional Input
connector
Table 2 Non- Supervised Input Terminal Blocks/RJ45
Board Configuration
Main Board Rdr/Door1
connector
Main Board Rdr/Door2
connector
Door Status (Drcnt) and Request to Exit (REX) for all doors may be
configured for Normally Open or Normally Closed contacts as supervised
or non-supervised. All inputs on the Controller Board and eight additional
inputs have default functions, but they can be configured for general
purpose inputs.
MPA2 Access Control Unit Installation Guide, Document 800-25395 - B
Panel Components and Descriptions
Terminal Block
P10 (GND, DoorCnt1)
P10 (GND, DoorCnt Aux1)
P18 (GND, DoorCnt1)
P18 (GND, DoorCnt Aux1)
P24 (GND, InputX (X=1-8))
Terminal Block
P10 (GND, REX1)
P10 (GND, REX Aux1)
P18 (GND, REX2)
P18 (GND, REX Aux2)
Installing the MPA2 Panels
RJ45
J12 (pin1,3)
J13 (pin1,3)
J14 (pin1,3)
J15 (pin1,3)
RJ45
J12 (pin2,3)
J13 (pin2,3)
J14 (pin2,3)
J15 (pin2,3)
7