SL1000
J12 & J15 do not configure the connection type on the system, they only add/remove the termination of the
circuit.
J13,J14 & J16, J17 do not configure the connection type on the system, they only select the polarity of the
connector J2/J3.
The 2BRIDB-C1 circuits must also be setup within the system configuration.
2. Connect the cables from the NT1 Network Termination cable to the J2 or J3 connector on the
2BRIDB-C1 daughter board.
Connector J2 - BRI1: Use switches J12, J13, J14
Connector J3 - BRI2: Use switches J15, J16, J17
Ensure that you set all switches correctly for each BRI circuit.
IP4WW-2BRIDB-C1
3.4.5 Cabling and Setting IP4WW-1PRIU-C1
This IP4WW-1PRIU-C1 PCB provides "RJ45" Modular Jack for one PRI connector.
2-50
J12
J15
J13 J14
J16 J17
J2
J3
Figure 2-78 Switches Location of 2BRIDB-C1
J5
PRI/E1/T1 Line
Figure 2-79 Connector of 1PRIU-C1
J12/15
ON OFF
T
S
T
S
J13/16
J14/17
ISSUE 1.0
Installation