Table of Contents
Advertisement
Display Board
Filter replacement time switches between 60 or 75 days
Operating Instructions
1. ON/OFF Control
Plug the unit in and the display will show the current room relative humidity. Press the on/off
button, and the machine will beep twice indicating it is ready for automatic service. If the
humidity is below setpoint, it will remain in standby condition. The on/off led will flash indicating
the unit is in standby mode. If the humidity is above setpoint, the unit will turn on and begin to
remove moisture from the room. The on/off led will be in constant on mode while the
dehumidifier is in on mode.
Press the on/off button again, and a single beep will indicate that the unit is turning off. No room
conditioning will occur until the unit is turned on again. The on/off LED will be turned off.
2. Setting the Humidity Level
Press the button to set indoor humidity. The humidity display
the actual room humidity level to the current setpoint. The humidity can be in 1% increments from
36-90%. Pressing the SET button increases the setpoint by 1% unit you reach 90%, then rolls over
to "CO" and increases from there.
3. Time
Humidity Display
12
LED
Humidity Setpoint Button
will shift from displaying
On/Off Button
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IW-25-4 and is the answer not in the manual?
Questions and answers