AdMore Lighting LEDV46-T-TS LIGHT KIT Installation Instructions

Congratulations on your purchase of the LEDV46-T-TS LIGHT KIT!

The LEDV46-T-TS LIGHT KIT will work on any motorcycle fitted with a top-mounted

GIVI V46 case. The kit is easy to install and significantly enhances your visibility on the

road and the good looks of your V46 case. Each kit contains one high intensity LED

circuit board that fits perfectly behind the original red lens of the GIVI case. The mini

controller embedded in the main power harness fits neatly under your motorcycle seat

or behind the tail light assembly. The mini controller allows you to connect the light kit

to your bike's tail light, brake light and turn signals! Your case lights will always be on

when riding, the lights will brighten when you apply your brakes and your lights will flash

with your turn signals.

To check for possible updates to this instruction set, please visit:

http://www.admorelighting.com/files/ADML-LEDV46-T-TS-14.pdf

(Please note: Link address is case sensitive and must be typed exactly as shown).

Please note: We make no guarantee that the LEDV46-T-TS LIGHT KIT is legal for

street use in your area. You should never rely on your LEDV46-T-TS LIGHT KIT

alone – always ensure that your stock brake light and turn signals are functioning

properly. The LEDV46-T-TS LIGHT KIT is intended to complement your bike's

original safety lights for added safety.

Rev.

1308

AdMore Lighting Inc. (2017)

Table of Contents

Need help?

Do you have a question about the LEDV46-T-TS LIGHT KIT and is the answer not in the manual?

Page 1 (Please note: Link address is case sensitive and must be typed exactly as shown). Please note: We make no guarantee that the LEDV46-T-TS LIGHT KIT is legal for street use in your area. You should never rely on your LEDV46-T-TS LIGHT KIT alone –...
Page 2 Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 Figure 6 Rev. 1308 AdMore Lighting Inc. (2017)
Page 3 Place provided heat shrink over the connector on the inside harness. Connect both connectors, slide heat shrink over both connectors and gently heat to secure. Proceed to LEDV46-T-TS LIGHT KIT Wiring Instructions Tidy up installation securing all cables. Use the included cable clamps to secure the cable to the inside of your case.
Page 4 LEDV46-T-TS LIGHT KIT Wiring Instructions Your AdMore Light Kit has been designed to operate with the tail, brake and turn signal light functions of your motorcycle or scooter. Using the supplied wire tap connectors, look as close to the rear taillight as possible to locate the indicated wires:...