MINN KOTA i-PILOT LINK Quick Reference Manual

Compatible with all Bluetooth
i-PILOT® LINK™ REMOTE
Screen
Navigation
Steer
Left
Prop
On/Off
Spot-Lock
Speed
Down
Dashboard
Info
Boxes
Touch
Screen
Active
Area
CONTROL BUTTONS
Home
Press to bring up the Home Screen
PROP
Buttons.
Screen Navigation
Press to navigate the menu without
touching the screen. Press and hold to
lock and unlock the remote.
PROP
Ok
Press to accept menu selections. Press
to power remote on. Press and hold for
3 seconds to power remote off.
Speed Up & Speed Down
Press to increase or decrease motor
speed.
Steer Left & Steer Right
Press to steer the motor to the left or
to the right.
Prop On/Off
Press to turn the Prop on and off.
Spot-Lock
Press to enable and disable Spot-Lock.
HEADER
Remote
Humminbird
Battery
Connection
GPS Signal
Strength
Motor Battery
t n
Displays motor battery level when prop
is disengaged.
Time
Displays the current time.
Remote Battery
Displays the battery level of the remote.
©2018 Johnson Outdoors Marine Electronics, Inc.
enabled i-Pilot Link Systems
® ® TM
Speed
Up
Ok
Steer
Right
Home
Header
Talon
Display
Screen
Content
i-PILOT LINK DASHBOARD
Area
PROP
High Speed
PROP
Bypass
SOG
PROP
SOG
PROP
INFO BOXES
TEMP 72 °F
TEMP 72 °F
Temperature
TEMP 65 °F
Talon
Time
Motor TEMP 65 °F
TEMP 72 °F BRG 359°
Battery
TEMP 72 °F BRG 359°
TEMP 65 °F HDG 255°
TEMP 65 °F HDG 255°
Only available with Ulterra.
t
TEMP 72 °F BRG 359°
GPS Signal Strength
Displays the level of GPS signal
strength. If no bars appear, or if the
TEMP 65 °F HDG 255°
bars are flashing, the system has not
yet acquired a GPS fix.
Humminbird Connection
Displays white arrows to show when the
i-Pilot Link controller is communicating
with the Humminbird. Grey arrows
indicate that there is no communication.
Talon
Displays the connection with one or two
Talons and indicates if the Talon(s) are
deployed. One Icon will display in the
event that one Talon is paired, and two
will display if two Talons are paired. The
icons will turn grey to indicate that the
Talon(s) is not connected.
SOG
Cruise
Prop
Prop Control
Speed
On/Off
Speed
Over Ground
Speed Over Ground
Displays the current speed over ground.
High Speed Bypass
Displays when High Speed Bypass is
engaged.
SOG
Prop On/Off
Displays when the Prop is enabled.
Rotates when the Prop is on and the
Prop Speed is greater than zero. Blinks
when a mode of navigation is used that
requires the prop to be enabled.
Cruise Control
Displays when Cruise Control is
engaged along with the Target Speed.
Prop Speed
Displays the current Prop Speed. Can
be adjusted in 1/2 speed increments
between 0 and 10.
BRG 359° DPTH
BRG 359° DPTH
Bearing
HDG 255° DPTH
HDG 255° DPTH
Heading DPTH 1 ft
Depth
DPTH 1 ft
Bearing
Bearing is the direction from the
boat's current location to the target
destination during navigation.
DPTH 5 ft
Heading
Heading is the direction that the motor
is pointing.
DPTH 5 ft
i-PILOT® LINK™
QUICK REFERENCE GUIDE
DPTH 1 ft
TEMP 72 °F
Temperature
The current water temperature based on
communication with the Humminbird.
DPTH 5 ft
Depth
The current water depth based on
communication with the Humminbird.
TEMP 65 °F
i-PILOT LINK HOME SCREEN BUTTONS
Legacy AutoPilot
The AutoPilot button is used to engage
and disengage Legacy AutoPilot.
Advanced AutoPilot
The AutoPilot button is used to engage
and disengage Advanced AutoPilot.
Record
The Record button is used to start and
stop recording an iTrack.
HSB
Select the HSB (High Speed Bypass)
button to engage High Speed Bypass.
mph
High Speed Bypass automatically sets
the Prop speed to 10. Double press to
engage. Single press to disengage.
Lock Keys
1.5
Select the Lock button to lock the
buttons and touch screen. Pressing and
holding the Screen Navigation
SOG
also locks and unlocks the remote.
Cruise Control
Press the Cruise Control button to
enable or disable Cruise Control. Once
Cruise Control is enabled, pressing the
Speed Up
buttons will change the Target Speed
rather than the Prop Speed.
Mark Waypoint
Press to mark a Waypoint.
Settings
Press the Settings button to open the
Settings menu and adjust settings
within the i-Pilot Link system.
Options
Press the Options button to open the
Options menu and adjust options
SOG
within the i-Pilot Link system.
Go To Spot-Lock
The Go To Spot-Lock button is used
to open a menu used to navigate to a
Spot-Lock location. The i-Pilot Link
system will only bring up Spot-Locks
within a quarter mile range.
Go To iTrack
1 ft
The Go To iTrack button is used to open
1 ft
a menu used to navigate to an iTrack.
The i-Pilot Link system will only bring
up iTracks within a quarter mile range.
5 ft
Go To Waypoint
The Go To Waypoint button is used
5 ft
to open a menu used to navigate to
a Waypoint location. The i-Pilot Link
system will only bring up Waypoints
within a quarter mile range.
Ulterra t
The Ulterra button is used to access
functions specific to controlling the
Ulterra.
Only available with Ultrex.
n
BRG 359° DPTH
HDG 255° DPTH
button
or Speed Down
minnkotamotors.com