IKEA FREKVENS F1720 Manual page 4

ENGLISH
TABLE OF CONTENTS
1. Volume Control
2. Power on/off
3. AC IN
4. AC OUT
5. AUDIO IN
6. AUDIO OUT
7. SUBWOOFER OUT
8. Handle with jumpers
9. Cover
10. Foot
11. Battery compartment lid for BRAUNIT battery pack,
sold seperately
Getting started
1. Connect mains cord into AC In (3) connector.
2. A quick press on the button (2) turns the speaker on/
off. White LED is now on. If a paired device is found,
the LED shines without blinking and your speaker is
ready to use.
3. If no device is found the speaker LED continues to
blink and enters pairing mode automatically. Go to the
Bluetooth settings in your mobile device and connect
to FREKVENS 10x20. The LED should now stop blinking
and your speaker is ready to use. If no music has been
playing for 20min, the speaker will enter sleep mode.
Adjust Volume
Turn the knob (1) left to decrease or turn it right to
increase volume level.
Pair Bluetooth device(s)
(maximum 8 devices can be stored)
1. Go to your Bluetooth menu on your mobile device and
connect to FREKVENS 10x20.
2. Once Bluetooth connection is established, the white
LED stops blinking.
Unpair Bluetooth device
Go to your Bluetooth menu on your mobile device and
unpair FREKVENS 10x20 from your devices.
Using an external source
Connect the external source to the AUDIO IN (5) jack
on the rear panel. The speaker automatically detects the
external input and disables Bluetooth functionality. Use a
3.5mm 3-pol Audio cable for this feature.
Using and charging the speaker
FREKVENS 10x20 has the possibility to be portable.
BRAUNIT battery pack is sold separately.
• To insert the battery, open the compartment lid (11)
and insert the battery in the correct direction.
• The battery is charged in the product when mains cord
is connected.
• When battery is low a red LED at the button (2) will
flash. During charging the red LED is on.
Accessories
Covers: pull off to detach and push on to attach.
Handle and jumpers: Attach/remove with two jumpers
and four screws using an Allen key.
Factory reset
Press button (2) 10 sec. This deletes all paired Bluetooth
devices.
Safety and important notice
WARNING:
— Risk of overheating! Never install the product in a
confined space. Always leave a space of at least 5 mm
around the product for ventilation. Ensure curtains or
other objects never cover the ventilation slots on the
product.
— Never place the product or batteries near open flames
or other heat sources, including direct sunlight.
— Only use this product indoors. The apparatus shall not
be exposed to dripping or splashing, no objects filled
with liquids, such as vases, shall be placed on the
apparatus.
4