Bluefin LED P24 Installation Manual

Bluefin Led Underwater lights.
P24 Single/Dual and Colourchange Installation manual.
Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested
rigorously to ensure optimum performance and longevity.
All Bluefin Led lights are water tested so please be aware there may be moisture present on the light.
Please ensure that your product is installed as per our instructions below, failure to do so may
invalidate your warranty.
Specs: electrical/fuse ratings
P24 SINGLE/DUAL
/COLOURCHANGE
Warnings:

Do not attempt to install the lights whilst the boat is in the water.

Ensure that the correct voltage is used for the light.

Ensure that an in line fuse is installed with the correct fuse rating per the light installed.

Ensure that you use the Screws provided with the o-ring fitted and only hand tightened
(failure to do so will invalidate your warranty).

Ensure all connections are made watertight.

Do not remove the Inline Moisture Guard.

Do not hold the light by the cable.

Do not use abrasives on the lenses.

Do not look directly into the light at close proximity.
Tools required for installation:

2.5mm(3/32") drill bit

17mm(17/25") drill bit

Drill

Posi head hand screwdriver

Marine sealant 3M 4200 or equivalent
1
Voltage Current
12/24v 12v10amp 24v5amp
only
Fuse rating
10amp