4
—
1. Panel cut-out dimensions
The old v4 HMI
206 ± 1
Panel cut-out
241 ±1
206 ±1
X1
The new v5 HMI
Horizontal center line remains the same for existing and
for the new HMI cut-out.
Minimum clearance required around the existing cut-out
without offcut gatherer: 10 mm (Y1 = Y2 = X1 = X2) as
illustrated.
Note! Minimum clearance required around the existing
cut-out with offcut gatherer is: 20 mm on both sides (X1, X2)
and top (Y1) and 50 mm on the bottom (Y2).
If offcut gatherer is not used, protect the personnel and
X2
the switchgear panel from flying offcuts.
241 ± 1
Panel cut-out