Hafco Metalmaster BS4A Assembly Instructions

BS4A (B002) Bandsaw Assembly Instructions
Shelf
Wheel Bracket
1. These are the components used in the assembly of the Stand.
3. Lay a Leg on the floor and fix one end of the Shelf as shown. (Note: The
Shelf will fit only one way—"tray" facing up). Do not fully tighten these
screws yet.
5. Fit the Corner Brackets inside a leg as shown. This is the end the Handle
will be fixed to. Finger tighten these 2 bolts first, then fully tighten.
7. Turn the Saw Stand up the right way, preferably on a non slip surface.
Lift the Saw on top of the Stand with 2 people ensuring the top of the
Stand fits inside the Saw Base. Make sure the motor is at the end with
the Wheel Bracket. Have the other person steady the Saw until all bolts
are tightened as it is unstable until completed.
Screws for Shelf
2. Using these screws, washers and
4. Fix the other Leg to the Shelf,
Wheel Bracket
6. Fit the Corner Brackets and
Page 1 of 3
nuts, fit the Shelf to the Legs.
again do not fully tighten these
screws.
Wheel Bracket to the other Leg.
Finger tighten these 4 bolts first,
then fully tighten.
4/2/2014