Secure CAREGIVER CAS-WCR Quick Start Manual

CODE MATCHING & MELODY SELECTION
Step 1: Insert batteries into the
transmitter to be used.
(CAS-FAM Fall Alarm
Monitor, CAS-SPT
Sensor Pad Transmitter
& Call Button, CAS-PIR
Motion Detector,
CAS-DWA Door/
Window Alarm,
CAS-TPC Toilet
Pull Cord Alert)
Step 2: Insert 3x C batteries
into the CAS-WCR
wireless receiver (Figure 2).
Step 3: Enter receiver pairing mode by pressing and holding
the zone select button for a few seconds until zone
light "I" begins to flash.
Step 4: Press the zone select button
to the zone you wish to pair with. Press melody
selector to scroll through the melodies.
Once you hear your preferred melody, do not press
again as it is now selected.
Step 5: Once the zone and melody are selected with the
zone icon flashing, trigger the transmitter once to
pair. If successful, the receiver will generate a short
tone. Press the
system is ready to use.
To stop the melody/alarm while it is alerting press the
reset button.
Personal Safety Corporation • Hiawatha, Iowa 52233 • 800.373.2873 • www.SecureSafetySolutions.com
Click here to view detailed product descriptions and prices.
WIRELESS RECEIVER
ALERT WITH BED
SHAKER AND
12V POWER ADAPTER
Model #: CAS-WCR • Made in PRC
Figure 2
again to switch
button to exit pairing mode, the

MOUNTING

POWER

Clearing a
Transmitter
from the
Receiver
Memory
Press and hold the zone selector button for 3 seconds to
enter the pairing mode. Press the
move to the desired zone you want to delete. Press & hold
the zone selector button &
together for 3 seconds to delete the memory. The receiver
will generate a tone to indicate the transmitter on the
specific zone selected has been deleted.

Changing Zone Melody/Alarm Sound

Press and hold the zone selector button for 3 seconds to
enter the pairing mode. Press the
move to the desired zone then press the
button to select the melody desired. Press the
selector button until the pairing mode is exited.

Low Battery Indicator

If a zone LED light begins blinking when in standby, it is an
indication that the batteries in the paired transmitter are
running low. Replace the transmitter batteries as soon as
possible.
If the receiver strobe light begins blinking every 5 seconds
when in standby, the receiver batteries are running low.
Replace the receiver batteries as soon as possible.
Note
Press the receiver RESET button to cancel an alert. The
RESET button is located on the back of the receiver behind
the flasher.
Call 800-397-5899 to order today!
zone selector button to
melody selector button
zone selector button to
melody selector
zone