Table of Contents
Advertisement
kneeling working position:
You can use the machine handle or the pipe bend to guide the
machine (fig. 43). You do not need to remove the extension.
In case you want to sand underneath a radiator, for example, you
can remove the machine handle from the attachment and install it
on the fan housing (fig. 44).
5.2 REPLACING THE ABRASIVES
ATTENTION!
•
Only use sanding discs with paper as the base! Do not use
any sanding discs with thick bases such as fiber discs,
cutting discs or similar materials! Otherwise the sanding
plate will be damaged!
•
Do not use any double sanding discs (with sanding grit on
both sides)! Otherwise the Velcro coating on the sanding
plate will be damaged!
•
Always use only one sanding disc! Otherwise the sanding
result will not be satisfactory and the dust suction system
will not be fully operational!
•
You will receive the best sanding finish and price/
performance ratio with the Velcro sanding discs from
LÄGLER
®
!
•
Each time you replace the abrasive, make sure that the
Velcro sealing strip on the attachment is correctly seated
(
Section 4.3, Installing the Velcro strip)!
Use the following abrasives only:
•
Velcro sanding discs
•
paper or fabric discs with 4 slits and a hole in the center with
a diameter of 22 mm (approx. 0.9")
•
sanding grid and pad with a hole in the center with a diameter of
22 mm (approx. 0.9")
The abrasive must have an external diameter of 178 - 180 mm
(approx. 7 - 7.1").
UNICO 01.07.2019
English / Englisch
5
WORKING WITH THE UNICO
Fig. 43
Working in kneeling position with the UNICO.
Fig. 44
Working in kneeling position with the UNICO.
31
Advertisement
Table of Contents
