Advertisement
8.1.6.
turn the engine switch to "stoP"
8.1.7.
tighten the drain screw.
8.1.8.
install the cover and tighten the screws.
8.1.9.
turn the fuel tank cap air vent knob to "off" after the engine has completely cooled down.
8.2.
engine
Perform the following steps to protect the cylinder, piston ring, etc. from corrosion.
8.2.1.
remove the spark plug and pour about one table spoon of clean engine oil into the spark plug hole and replace spark plug. Pull start
cord to turn over the engine several times to coat the cylinder walls with oil.
8.2.2.
Pull the recoil starter until you feel compression. then stop pulling (this stops the cylinder and valves from rusting.
8.2.3.
clean exterior of the generator. store the generator in a dry, well ventilated place , with a cover paced over it.
9. trouBlesHootIng
9.1.
engine will not start
9.1.1.
no fuel supplied to combustion chamber.
no fuel in tank................supply fuel.
fuel in tank.....................turn fuel air vent and fuel knob to "on".
Clogged fuel filter............Clean fuel filter.
clogged carburettor.........clean carburettor.
9.1.2.
Engine oil system insufficient.
oil level is low..................Add engine oil.
9.1.3.
electrical systems
Poor spark. spark plug dirty or wet.........remove spark plug and clean/dry
faulty ignition system..........consult authorised stockist.
9.1.4.
Generator will not produce power
Press the dc protector to "on"
the Ac pilot light (Green) goes off.......stop the engine and restart.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMportant: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
01284 757500
01284 703534
G2000i.V2 | issue 1 05/09/16
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
