Setting The Sleep Timer; Displaying Tv Setting Information On-Screen Using Recall - Toshiba REGZA 32HLV66 Operation Manual

Integrated high definition lcd tv/dvd combination
Hide thumbs Also See for REGZA 32HLV66:
Table of Contents

Advertisement

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length
of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press [ on the remote control to set the length of time until
the TV turns off. Repeatedly press [ to increase the time in
10-minute increments, or press B or b to increase or decrease
the time in 10-minute increments, to a maximum of 180
minutes.
To set the sleep timer using the on-screen menus:
1
Press Y and open the Setup menu.
2
Highlight Sleep Timer and press T.
Setup
Installation
Sleep Timer
PC Settings
PC Audio
HDMI Audio
Slide Show Interval
Navigate
ENTER
Select
3
Press the Number buttons to enter the length of time in 10-
minute increments.
Sleep Timer
Enter total minutes until the TV
turns off automatically (Maximum
180 minutes)
Cancel
4
Highlight Done and press T.
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep time:
Press [.
Sleep Timer
120 Minutes
Note: A message will display on-screen when there is one
minute remaining on the sleep timer.
To cancel the sleep timer:
Press [ until it is set to 0 minute.
40
Chapter 5: Using the TV's features
No
Auto
2 Sec
Back
Exit
CH RTN
EXIT
1 2 0
Done
Displaying TV setting information
on-screen using RECALL
To display TV setting information on-screen:
Press E on the remote control.
The following information will display on-screen
(if applicable):
Current input (ANT 1, VIDEO 1, etc.)
If ANT 1 is the current input, either "CABLE" (for cable
TV) OR "TV" (for over-the-air broadcasts)
Channel number (if in ANT 1 mode)
Digital signal strength indicator (bar graph in lower right
corner of screen; for ATSC signal only)
Note: The signal strength indicator will react to fading and
increasing signals.
Remaining time on sleep timer (if set)
Stereo or SAP audio status
V-Chip rating status
Picture size
Video resolution
STEREO
NC-17
Sleep Timer: 18 min.
Natural
480i
Sample RECALL screen
To close the RECALL screen:
Press E again.
ANT 1
81-1
CABLE

Advertisement

Table of Contents
loading

This manual is also suitable for:

37hlv6626hlv66

Table of Contents