Toshiba Strata DK 16 Installation And Maintenance Manual page 288

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
STEP
1 Enter Program Mode
At the >MODE prompt, enter PROGCR
2 Enter Program Number 60
.
CR
Press
3A SMDR Threshold Time
Enter: Item code 2.
The system will display either "0" or "1". "0" indicates that the
threshold time is set at 0.1 seconds. "1" indicates 10 seconds.
The default is "1".
Refer to the System Record Sheet, and enter the correct digit—
if it is not already being displayed—and then CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3B
Allow SMDR printout.
Enter: Action code 3.
System will print out "1" if incoming and outgoing calls will be
printed on SMDR. A "0" will be printed out if only outgoing calls
will be printed.
Refer to the System Record Sheet and change (to 1 or 0), if
required, and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3C Set Account Code Digit Length
Enter: Item code 4.
The system will display the number of digits allowed in the
account code. The default is 06.
Refer to the System Record Sheet and enter the required number
of digits (04 ~ 15) and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3D SMDR Toll Calls Only
Enter: Action code 5.
The system will display the presently selected feature (0 ~ 5).
The default is 0. Refer to the System Record Sheet and enter the
required feature code and press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3E Enter DISA ID Code
Enter: Item code 6.
System will display last entered ID code number. Default = Blank.
Refer to the System Record Sheets, and enter a new code if
desired, and then press CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
3F Credit Card Call Digit Length
Enter: Item code 7.
The system will display the current digit length.
Refer to the System Record Sheet, and enter the desired length,
01 ~ 30 digits, and then CR. Example: 13 digits; enter 1 3 CR.
If you wish to change another parameter within this program,
enter its associated item code. To exit this program, go to step 4.
4 To Exit Program/Store Data
Press # # CR.
TABLE RM-AH
PROGRAM 60
SMDR OUTPUT/ACCOUNT CODE DIGIT LENGTH
ACTION
.
-38-
DISPLAY/PRINTOUT
>MODE PROG
P
P 60
P60
P60 21
P60 3 1
P60
P60 4 06
P60 5 0
P60 6 NNNN
P60 7 13
P60 6 NNNN
P60 ##
P