Step 2: Power Up Dkadmin Pc - Toshiba Strata DK Admin User Manual

Step 2: Power Up DKAdmin PC

From C:\280ADMIN\Data, type del *.ntx and press Enter.
From C:\280ADMIN\XXX.DK, type del *.ntx and press Enter.
Run ReIndex Files under Options/System Utilities Menu each time before you start to use
DKAdmin.
Always exit DKAdmin before you turn your computer off.
Step 2: Power Up DKAdmin PC
Note The DKAdmin Hardware Key must be installed on the PC LPT1 port, to enable the
DKAdmin program to be used after it is installed. If you install DKAdmin without the
key, it will not run.
1. Install the DKAdmin hardware key (red) on the LPT1 parallel printer port as shown in
Figure 2.
IBM Compatible
Personal Computer
1994
Figure 2
Notes
If you wish, you can install a printer on the end of the LPT1 Admin Hardware Key.
The printer can be installed and used on the LPT1/Admin Hardware Key. But, it is not
necessary to install a printer to enable DKAdmin to be installed or used.
2. Turn on your computer.
8
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Red DKAdmin Hardware Key (required for DKAdmin)
DKAdmin
4E L V CH - B
LPT1 Parallel Printer
Connector on Back
DKAdmin Hardware Connections
Parallel Printer
Screws Cable
Parallel Printer Port
Printer
DKAdmin/DKBackup