Adjusting Lift−O−Matic Device - New Holland TD60D Repair Manual

SECTION 35 − HYDRAULIC SYSTEM − CHAPTER 1
8. Move the draft control lever (2) to a distance (L
of 105 − 115 mm (4.1338 − 4.5275 in.) from the
beginning of the slot and check that at this
position the arms start to rise.
9. If they do not, adjust the eccentric pin (1) fig. 60,
to restore this distance.
10. Fasten the eccentric pin using the securing bolt
(1) fig. 61.
Adjusting LIFT−O−MATIC device
Proceed as follows:
11. Move the position control lever (1) and the draft
control lever (2) fully forward in the sector.
12. Raise the lift arms by means of the lever (1).
13. Tighten the nut (1) fig. 72, until the arms lower.
14. With the lever (1) fig. 71, still in the same
position, unscrew the nut (1) fig. 72, until the
arms begin to rise.
15. Unscrew the nut (1) by another 1.5 turns.
16. Using the levers (1) and (2) fig. 71, lower and
raise the arms a few times to ensure that the
system is operating correctly.
)
2
TRE0109A
TRE0116A
TRE0017A
TRE0117A
L2
1
1
2
1
2
1
603.54.471.00 − 11 − 2004
35
2
69
70
71
72