Field Bus Sercos Ii (Frx, Ftx); Operator Interface (Hmi); Usb (Usb) - Smitec Cosmos Series Installation, Use And Maintenance Manual

5.3.11 Field bus Sercos II (FRX, FTX)

The field bus connection allows the drivers communication with a control system.
Connector type: SMA for plastic optical fiber - 1mm (not supplied)
Order code: --------
Features
The communication bus is based on 660nm optical transmission on plastic fiber.
Connector FRX
Colour
Dark grey Reception
Connector FTX
Colour
Light grey Transmission

5.3.12 Operator interface (HMI)

This is a specific connection for the operator interface VISIO 3000.

5.3.13 USB (USB)

This connection is a standard USB port 2.0 for firmware updating and diagnostic purposes. The connector type installed
in the driver is 5-pin USB Mini-B, very common in hand-held devices.
The USB port must be used exclusively for diagnostic purposes or for firmware updating. It is not
allowed during the driver normal operation.
Ver. 1.07
COSMOS DRIVER SERIES 3000 - USE AND MAINTENANCE MANUAL
Signal
Signal
Conductor cross section
Pag. 47