FFM-TITAN-1200 USER MANUAL CONTENTS BEFORE YOU BEGIN ..................................1 What Is Included ................................1 Unpacking Instructions ..............................1 Symbols ....................................1 Disclaimer ................................... 1 Safety Notes ..................................1 1.5.1 Personal Safety ....................................1 1.5.2 Mounting and Rigging .................................. 1 1.5.3 Power and Wiring ....................................
Disclaimer The information and specifications contained in this User Manual are subject to change without notice. FROGGYS FOG assumes no responsibility or liability for any errors or omissions and reserves the right to revise or to create this manual at any time.
Description The Titan 1200 is a powerful 1300W Fog Machine with over 20,000CFM. The efficient heater core increases run times, Quick Ready Fog Technology (QRFT) has you ready to fog in less than 10 seconds after full cycle and it is ready to fog, and Advanced Low Fluid Sensing shuts...
FFM-TITAN-1200 USER MANUAL Features • 1300W • 20,000 CFM • Oversized Heater Core for increased run times • Quick Ready Fog Technology (QRFT) - Less than 10 seconds after full cycle and it is ready to fog • Advanced Low Fluid Sensing •...
Always mount this product in a safe position and make sure there is adequate room for ventilation, configuration, and maintenance. 4.3.2 Rigging FROGGYS FOG recommends using the following general guidelines when mounting this product. • Before deciding on a location for the product, make sure there is easy access to the product for maintenance and programming purposes.
FFM-TITAN-1200 USER MANUAL • The machine will begin heating once the unit has been turned on. • When the Green button is illuminated, the machine has come up to temperature. • Press the illuminated button to trigger fog output. Timer Remote Control Mode & Operation The wired timer controller allows you to automatically trigger fog output by setting interval and duration times.
120 degrees and humid/damp locations which may cause control board failure. 11. If possible, remove from storage after 6 months and operate the machine for 15 minutes or more, then repeat step 8 – 10. Test-run your FROGGYS FOG® FFM-TITAN-1200 on a monthly basis to achieve the best performance.
FFM-TITAN-1200 USER MANUAL Storage 6.2.1 Machine Storage Before storing the machine, clean it as described in the cleaning procedure above; however, only follow steps 1 through 5. Do not refill the tank with fog fluid if storing the machine. Cleaning the system prior to storage will help prevent any particles from condensing inside the pump or heater while not in use.
Need help?
Do you have a question about the TITAN 1200 and is the answer not in the manual?
Questions and answers