Asus Hyper M.2 x16 Gen 4 Quick Start Manual page 5

5. Peel the plastic films off the thermal pads, secure the cover to the ASUS HYPER M.2
X16 GEN 4 CARD with the cover screws that you removed earlier, then install the
ASUS HYPER M.2 X16 GEN 4 CARD into a PCI Express 4.0/3.0 slot.
6. Enter the BIOS Setup during POST to configure your BIOS settings.
• For Intel
®
Configuration, then set the PCIe slot(s) that you have installed the Hyper M.2
x16 card(s) to the following:
- [Hyper M.2 X16(VROC)] to create a VROC RAID configuration using only
the PCIe slots set to this option.
- [Hyper M.2 X16(DATA)] to support up to 4 x M.2 storage devices installed
on the Hyper M.2 X16 expansion card without VROC support.
• For other Intel
Configuration, and set Hyper M.2X16 to [Enabled].
• For AMD motherboards, go to Advanced > Onboard Devices Configuration,
then set the PCIe slot(s) that you have installed the Hyper M.2 x16 card(s) to
[PCIe RAID Mode].
For more information on RAID configurations on
the installed M.2 storage devices, please refer to
the RAID Configuration Guide by scanning the
QR code.
X299 Series motherboards, go to Advanced > CPU Storage
Series motherboards, go to Advanced > Onboard Devices
®
5