Target Audience: These instructions are designed for use by maintenance professionals or lock installers who are familiar with common safety practices and competent to perform the steps described. dormakaba is not responsible for damage or malfunction due to incorrect installation however arising.
EUROPEAN LOCK CASE EUROPEAN STRIKE CYLINDER ROSE EUROPEAN CYLINDER (may have to purchase separately) CYLINDRICAL LATCH ASM MORTISE dormakaba Canada Inc. 7301 Decarie Blvd. Montreal Quebec Canada H4P 2G7 1309 - CPR - 0360 EN 12209:2003/AC:2005 3S510G3HH1D None Saffire LX...
Components 3.2 European lock case ALL OPTIONS SHOWN EUROPEAN CYLINDER EUROPEAN LOCK CASE dormakaba DeutschlandGmbH DORMA Platz 58256 Ennetpetal Germany 0432-CPR-00026-99 EN 12209:2003/AC:2005 3X810G6HC20 None Saffire LX PK3704_T 02-19...
Secure the access plate using two screws item 10 (refer to table 2) WARNING • Access plate must be installed for proper operation of the lock. To identify the item numbers CAUTION listed below, refer to Table 2. IMPORTANT Saffire LX PK3704_T 02-19...
• Insert the thumb turn spindle item 2 (refer to table 2) into the thumb turn hole. Press firmly to ensure the spindle clicks in place. • Rotate the spindle to ensure that the part remains in place. Index markers to be aligned Saffire LX PK3704_T 02-19...
• Turn the hub for correct door handing by turning clockwise for right handed and counter clockwise for left handed door entries. Right (RH) RH VIEW Left (LH) LH VIEW • Insert the spindle item 1 (refer to table 2) smoothly until it clips. Saffire LX PK3704_T 02-19...
If the handing of the lock needs to be changed, please refer to annex C for changing the handing of the cassette if the lock has a handed cassette (locks with automatic dead bolt or with inside lever switch). Saffire LX PK3704_T 02-19...
Before starting the installation of the lock on the door, please make sure the door has been prepared properly with proper holes for the lock. Refer to corresponding drilling template for your lock model. Drilling templates are available in the cen- terfold included in this installation manual and on the dormakaba support site (dormakabalodgingsupport.com). Saffire LX...
• Insert the mortise in the side of the door. If the mortise is equipped with a cable, route the cable so it comes out of top hole on the side of the inside trim assembly. Saffire LX PK3704_T 02-19...
Page 13
When strike is installed on wood frames under one inch (1”) thick, wood screws supplied are not adequate. Use screws of appropriate length to engage the structural stud behind the frame. Use only the strike and dust box supplied. Use of non- approved parts may void the product warranty. Saffire LX PK3704_T 02-19...
1-7/8" (48mm) to 1-15/16" (49mm) 5/8 (16mm) 2" (51mm) to 2-1/16" (52.5mm) 3/4 (19mm) 2-1/8" (54mm) to 2-3/16" (56mm) 3/4 (19mm) 2-1/4" (57mm) to 2-5/16" (59mm) 7/8 (22mm) 2-3/8" (60mm) to 2-1/2" (64mm) 7/8 (22mm) Cylindrical Unit Assembly Saffire LX PK3704_T 02-19...
Page 15
• Install the strike and the dust box on the door frame. IMPORTANT Use only the strike and strike box supplied. The use of non-approved parts will result in a functionality problem and may void the product warranty. ASA Strike Saffire LX PK3704_T 02-19...
If not, it means the lock handing is wrong; then fix the handing correctly and verify again. • Verify the inside lever handle comes freely to horizontal rest position after being activated. If not, re-align lock on the door. ASM and cylindrical latch European lock case Saffire LX PK3704_T 02-19...
4.10. Step 7 Install the antenna module (if applicable) • Position the bracket on the door, engaged with the “T” at the top of the chassis. • Secure the bracket with screw provided with the bracket. Saffire LX PK3704_T 02-19...
• Remove the cover on the wire cover. The cover will no longer be used. • Now that cables are exposed, connect each cable with its matching connector. • Push back the wire guide in the door. Saffire LX PK3704_T 02-19...
• When the cover is fully in place, secure it using the 3 screws item 5 (refer to table 1). • For locks with an ADB mortise (automatic deadbolt mortise), apply the privacy thumbturn sticker. R/H Locks L/H Locks Saffire LX PK3704_T 02-19...
F - Release inside lever, should move freely back to horizontal rest position. G - Check bolt projection from thumbturn, should be smooth. 4.16. Step 13: Program the lock Refer to dormakaba access management system user manual for lock programming. Saffire LX PK3704_T 02-19...
Release the deadbolt (D) gently. It should extend to 5/16" approx. and stop. If the deadbolt extends past this point, gently press it in until it locks at 5/16" throw, or start step 2 again. Proceed to step 3. 5/16" Saffire LX PK3704_T 02-19...
Page 22
Release the latch to the middle of the stroke and hold it there. Use a small screwdriver to push the lock mechanism back on lock position (see step 1 and 2) . IMPORTANT The lock mechanism has to be horizontal on lock position Saffire LX PK3704_T 02-19...
Page 23
If the auxiliary latch (X) is a crescent shape, remove it, turn it 180°, and replace it. The auxiliary latch slides easily in and out of the mortise. (re-insert) 180° For RH (right hand) and LHR (left hand reverse) X (crescent = must be reversed) Saffire LX PK3704_T 02-19...
Annex B Reversing the European lock case handing Saffire LX PK3704_T 02-19...
Page 25
2. Flip the top plate and reinstall on the cassette. You should see now the other letter for the handing. Secure the top plate with the screw. The cassette is on the LEFT HAND inside trim assembly RIGHT HAND Saffire LX PK3704_T 02-19...
Annex D Installing Outside Housing with Gasket Saffire LX PK3704_T 02-19...
Page 27
Customer services & support 1.800.999.6213 / +1.248.837.3700 General information: www.dormakaba.us Online consumable orders: www.saflokstore.com To access all of our easy steps, please visit our support website: www.dormakabalodgingsupport.com www.dormakaba.com...
Need help?
Do you have a question about the Saffire LX and is the answer not in the manual?
Questions and answers