Replacing The Sensor; Pc Software - Honeywell Envitec MySignO Operating Manual

5.2

Replacing the sensor

1. Remove the sensor
2. Return the sensor
3. Connect a new sensor and check its functions
4. Calibrate the sensor.
The oxygen measuring device MySign O may only be used with the oxygen sensor
type OOM111 (Part No. 01-00-0114) in order to guarantee the stated specifications.
6

PC software

The integrated USB port can be used for exchanging data between a computer and MySign
O. The steps for connecting the relevant cables for exchanging data and for charging the
battery from the computer port are identical (see section "Commissioning").
It is only possible to transfer data to a computer once the software has been installed.
The software can be used to:
Read-out/analyse measured data
Save and upload measured data
Please refer to the "Help" section of the PC software for more information on
operation and the functions of the PC software.
Connecting the MySign
Start up the software application
Connect the PC to the MySign
Switch on the monitor
Connecting the monitor to the PC software will interrupt the current measurement!
It is not possible to conduct any measurements while connected to the PC.
Doc no.: 065-07-1001825_MySignO_GB-0.pdf / 12.11
®
O monitor to the PC software
®
O monitor with a USB cable
Oxygen measuring device MySign
Maintain patient data
Configuring the MySign
Press "OK" to connect the monitor to the PC
software.
®
O
®
®
O
39