Modifications; Cables; Regulatory Compliance Identification Numbers; Laser Device - HP StorageWorks HA-Fabric Manager Installation Manual

Modifications

The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by Hewlett-Packard Company may void the
user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI
connector hoods in order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product
has been assigned a unique Regulatory Model Number. The RMN can be found on the
product nameplate label, along with all required approval markings and information.
When requesting compliance information for this product, always refer to this RMN.
The Regulatory Model Number should not be confused with the marketing name or
model number of the product.

Laser device

All HP systems equipped with a laser device comply with safety standards, including
International Electrotechnical Commission (IEC) 825. With specific regard to the laser,
the equipment complies with laser product performance standards set by government
agencies as a Class 1 laser product. The product does not emit hazardous light.

Laser safety warning

WARNING!
To reduce the risk of exposure to hazardous radiation:
• Do not try to open the laser device enclosure. There are no user-serviceable
components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser
device other than those specified herein.
• Allow only HP authorized service technicians to repair the laser device.
HP StorageWorks HA-Fabric Manager Appliance installation guide FW07.00.00/HAFM
SW 08.06.00
71