Measure:preshoot - Keysight P9241 Scpi Programmer's Manual

:MEASure:PREShoot

Command Syntax
:MEASure:PREShoot [<source>]
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :MEASure:PREShoot command installs a screen measurement and starts a
preshoot measurement. If the optional source parameter is specified, the current
source is modified.
Query Syntax
:MEASure:PREShoot? [<source>]
The :MEASure:PREShoot? query measures and returns the preshoot of the edge
closest to the trigger, displayed on the screen. The method used to determine
preshoot is to make three different vertical value measurements: Vtop, Vbase, and
either Vmin or Vmax, depending on whether the edge is rising or falling.
For a rising edge:
For a falling edge:
Vtop and Vbase are taken from the normal histogram of all waveform vertical
values. The extremum of Vmax or Vmin is taken from the waveform interval right
before the chosen edge, halfway back to the previous edge. This more restricted
definition is used instead of the normal one, because it is likely that a signal may
have more overshoot than preshoot, and the normal extremum would then be
dominated by the overshoot of the preceding edge.
Return Format
<value><NL>
<value> ::= the percent of preshoot of the selected waveform
See Also •
•
•
•
•
•
Keysight P9241/42/43A Oscilloscopes SCPI Programmer's Guide
(see page 1196)
preshoot = ((Vmin-Vbase) / (Vtop-Vbase)) x 100
preshoot = ((Vmax-Vtop) / (Vtop-Vbase)) x 100
in NR3 format
"Introduction to :MEASure Commands"
":MEASure:SOURce" on page 472
":MEASure:VMIN" on page 489
":MEASure:VMAX" on page 488
":MEASure:VTOP" on page 493
":MEASure:VBASe" on page 487
:MEASure Commands
on page 432
21
463