Canon EOS-1D X Mark III Advanced User's Manual page 573

Connecting Manually to Detected Networks
Instructions in this section are continued from
Connect to an access point by selecting its SSID (or ESS-ID) in a list of active access points
nearby.
Selecting the access point
1.
Select an access point.
(1) SSID
(2) Security icon (only for encrypted access points)
(3) Channel used
Note
[Refresh]
To display [Refresh], scroll down the screen in step 1.
Select [Refresh] to search for access points again.
Entering the access point encryption key
Enter the encryption key (password) set on the access point. For details on the
encryption key that has been set, refer to the access point's user manual.
The screens displayed in steps 2–3 vary depending on the authentication and
encryption set on the access point.
Go to Setting the IP Address
screens shown for steps 2–3.
Turn the < > dial to select the access point to connect to in the list of
access points.
if the [IP address set.] screen is displayed instead of the
Checking the Type of Access
573
Point.