Configuration Commands; At&F Reset At Command Settings To Factory Default Values - Gemalto CINTERION BGS2T At Command Set

BGS2T AT Command Set

2. Configuration Commands

2. Configuration Commands
The AT Commands described in this chapter allow the external application to determine the BGS2T's behaviour
under various conditions.
2.1 AT&F Reset AT Command Settings to Factory Default Values
resets AT command settings to their factory default values.
AT&F
Every ongoing or incoming call will be terminated.
For a list of affected parameters refer to Section 19.6,
AT&F.
Syntax
Exec Command
AT&F[<value>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + +
Parameter Description
(num)
<value>
[0]
BGS2T_ATC_V01.301
Confidential / Released
+ - -
Reset parameters in Section 19.6,
able with AT&F
Page 33 of 554
Factory Default Settings Restorable with
Reference(s)
V.250
Factory Default Settings Restor-
to their factory default values.
c
1/31/12