Related Manuals for eletab ELTGM05-2
Summary of Contents for eletab ELTGM05-2
- Page 1 ELTGM05-2 (1.5~8kg)x2 (3.3~17.6lbs)x2 RA TED EleTab_service@outlook.com www.facebook.com/EleTabus...
- Page 2 Read the entire instrution manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, Please contact at EleTab_service@outlook.com for assistance. CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
-
Page 3: Tools Required
Parts Tools required O (x1) P (x1) Q (x1) Phillips 4mm Allen 6mm Allen Screwdriver Wrench Wrench Wrench (not included) Components A (x1) B (x2) C (x1) D (x1) E (x1) F (x1) G (x1) VESA Plate Clamp Base Clamp Cable Clip Long Screw Base Support... - Page 4 STEP 1 Choose a mounting option OPTION A: Clamp Installation Install clamp base support (C) onto base of monitor stand (A) with bolts (M) using provided 4mm Allen wrench (O). Apply pads (N) to bottom of base to prevent table top from being scratched.
- Page 5 Secure clamp (D) to upper two holes with Secure clamp (D) to lower two holes with bolts (L) using 4mm Allen wrench (O) for bolts (L) using 4mm Allen wrench (O) for desks with a thickness of 10-55mm. desks with a thickness of 50-85mm. Attach base support cover (E)to clamp base support (C).
- Page 6 STEP 1 (Continued) OPTION B: Grommet Base Installation Slide long screw (F) through the top of the grommet base support (G) and install on base of monitor stand with bolts (M) using 4mm Allen wrench (O). Apply pads (N) to bottom of base. Position stand on desk with long screw through hole, and secure by using the support plate (H) and washer (J) on underside of the mounting surface, tighten the nut (I) with wrench (Q).
- Page 7 STEP 2 Attach the monitors to the arm OPTION A: Flat Back Monitor Attach the VESA plate (B) to back of monitor and secure with screws (M-A) or (M-C) with washers (M-E). Avoid excessive tightening screws damage the monitor. OPTION B: Curved Back Monitor Attach the VESA plate (B) to back of monitor and secure with screws (M-B) or (M-D) with washers (M-E) and washers (M-F).
-
Page 8: Step 3 Adjust The Tension
Slide the monitor onto the head of swivel arm, install the security nut (K). Make sure the security nut is installed before you rotate the monitor. STEP 3 Adjust the tension Adjust gas spring tension by turning Be sure to keep the arm in horizontal screw with 6mm Allen wrench (P) . -
Page 9: Step 4 Cable Management
STEP 4 Cable Management For both bottom and upper portion of the spring arm, just slide the cable cover up and away from the spring arm, do not need to take much effort to pull the ends of the cable cover away from the spring arm. -
Page 10: Warranty & Service
We encourage you to write a review sharing your experierience. Should you have any issues, please don't hesitate to contact us. Scan the qr code below for more products from EleTab For further services: EleTab_service@outlook.com...
Need help?
Do you have a question about the ELTGM05-2 and is the answer not in the manual?
Questions and answers