CAME GARD Series Installation Manual page 18

ACTIVATING THE RADIO CONTROL
Connect the RG58 cable antenna cable to the corresponding terminals .
 For TOP and TAM series transmitting on 433.92 MHz, set the jumper-switch of the AF43S card as shown in the figure
.
Plug the AF card, that is, the AF43S or the AF868 into the connector on the control board .
⚠ Before fitting the AF card, you MUST CUT OFF THE MAIN POWER SUPPLY and, remove any emergency batteries.


Keep pressed the PROG programming button on the control board. The programming LED fl ashes.
Press any key on the transmitter you want to memorize. The LED stays on to indicate that memorization has been successful.


PROG button
TOP

AF card, either AF43S or AF868
ON
1 3 4 5 6 7 8 9 10
2
TAM
AF43S card
Programming LED
Programming LED