Restored To Factory Setting (System Reset) - ITech IT8000 Series User Manual

5.13 Restored to Factory Setting (System Reset)

This menu item is used to restore some parameter settings to factory setting
values.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Press the Up/Down key or turn the knob to select the System Reset and
3. Press the Left / Right key or turn the knob to adjust the value of this
4. After the parameter settings are complete, press [Enter].
ter the system menu.
press [Enter].
parameter.
•
No: Default value, indicates the instrument cancels this menu setting.
•
Yes: Indicates the instrument restores the factory default settings.
The parameters affected by System Reset and the parameter values after
reset are shown in the following table.
Table 5–3 Initial value of the parameter
Parameter
Category
Main Voltage setting under CV mode:
interface Vs
Current setting under CC mode:
Is
Power setting under CW mode:
Ps
Copyright © Itech Electronic Co., Ltd.
Basic Operation
Initial Value
Rated voltage of the
instrument
0A
0W
103