Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Menards KLEARVUE CLOSETS
- Page 1 INSTALLATION GUIDE AVAILABLE AT...
-
Page 2: Table Of Contents
BEFORE YOU BEGIN INSTALLATION You can organize each closet configuration by its SKU. VERIFYING YOUR ORDER Verify that all hardware, shelves, closet uprights, fronts, This is listed on the design list of the design packet, moulding and accessories you purchased are on site. A along with the quantity needed. -
Page 3: Preparation
PREPARATION Closets fit best on square walls. Walls that are out Snap a chalk line or draw a level line at 84-3/4" from the of square will require modification to ensure closet highest point of your finished floor. It may be helpful installation goes smoothly. - Page 4 Align the cam locks (included in the cam lock pack Once all shelves have been installed in your closet from the shelf kit) into the shelves, making sure the base, verify it is square and plumb. Secure the closet open ends match up. Firmly press the cam locks into using an L-bracket (478-5050) into a wall stud and on the holes.
-
Page 5: Doors, Drawers, Closet Rods & More
CLOSET UPRIGHTS Once cabinet connector installation locations have been determined, insert cabinet connectors and fasten using a Phillips head screwdriver until tight. We suggest using cabinet connectors in each corner of the uprights. Once the connectors are installed, remove clamps. Note: If cover panel is required between closet bases, cabinet connectors will not be needed. -
Page 6: Cover Panels, Moulding & Toe Kicks
COVER PANELS, MOULDING AND TOE KICKS COVER PANELS TOP MOULDING Exposed ends of closet uprights have the option Top moulding is an additional look that can be added to be finished with a cover panel. Place cover panel to your closet design. Follow step-by-step instructions to the upright, lining up to be flush to the top of the included with the moulding hardware. -
Page 7: Shelf & Drawer Location
SHELF & DRAWER LOCATIONS CAM LOCK DOWEL LOCATIONS CAM LOCK SHELF LOCATIONS 14" depth uprights and shelves will require cam dowels All shelves will be installed in the top row of holes on to be installed in the front column of holes and back the upright. -
Page 8: Drawer Locations
DRAWER LOCATIONS DRAWER LOCATIONS - 3 DRAWER BANK DRAWER LOCATIONS - 2 DRAWER BANK This configuration is made from Medium Drawer Kits. This configuration is made from Tall (High) Drawer Kits. Follow step-by-step instructions with your drawer kit. Follow step-by-step instructions with your drawer kit. Refer to this layout for glide installation location.
Need help?
Do you have a question about the KLEARVUE CLOSETS and is the answer not in the manual?
Questions and answers