Table of Contents
Advertisement
Quick Links
INSTRUCTIONS
PARTS LIST
Trailer Hitch Kit
P/N 08L92-TGS-100
Trailer hitch
Trailer hitch cover
Receiver cover
6
Flange bolts
Ball Mount Kit
P/N 08L92-TGS-100A
Ball mount
Hitch pin
© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
Accessory
TRAILER HITCH
Hitch pin clip
TOOLS AND SUPPLIES REQUIRED
Shop towel
10 mm Open end wrench
Ratchet
Torque wrench
10 mm and 18 mm Sockets
Phillips screwdriver
File
5 mm Hex wrench
The following tools are available through the Honda Tool
and Equipment Program. On the iN, click on Service >
Service Bay > Tool and Equipment Program, then enter
the number under "Search." Or, call 888-424-6857.
• Trim Tool Set (T/N SOJATP2014)
• Plastic Trim Tool (T/N SILTRIMTL10)
• Air saw (T/N AT192A)
Illustration of the Trailer Hitch on the Vehicle
AII13220-10 (1911)
Application
2020 PASSPORT
TRAILER HITCH
08L92-TGS-1000-90
Publications No.
VERSION 1
Issue Date
NOV 2019
1 of 8
Advertisement
Table of Contents
Related Manuals for Honda 08L92-TGS-100
Summary of Contents for Honda 08L92-TGS-100
-
Page 1: Installation Instructions
• Air saw (T/N AT192A) Flange bolts Illustration of the Trailer Hitch on the Vehicle Ball Mount Kit P/N 08L92-TGS-100A Ball mount Hitch pin TRAILER HITCH 1 of 8 © 2019 American Honda Motor Co., Inc. – All Rights Reserved. AII13220-10 (1911) 08L92-TGS-1000-90... - Page 2 (Wrap with a shop towel.) • Remove the intake air tube. • Disconnect the negative cable from the battery. INTAKE AIR 2 CLIPS TUBE 2 of 8 AII13220-10 (1911) © 2019 American Honda Motor Co., Inc. – All Rights Reserved.
- Page 3 REAR RETAINING 4 CLIPS BUMPER Repeat steps 3 through 5 on the left side of the vehicle. 2 BUMPER REAR SCREWS BUMPER 3 CLIPS 3 of 8 © 2019 American Honda Motor Co., Inc. – All Rights Reserved. AII13220-10 (1911)
- Page 4 REAR CONNECTOR 8 RETAINING BUMPER (If equipped) TABS 4 BOLTS REAR BUMPER REAR BUMPER LOWER COVER HANDS-FREE ACCESS UNIT CONNECTOR (If equipped) 4 of 8 AII13220-10 (1911) © 2019 American Honda Motor Co., Inc. – All Rights Reserved.
- Page 5 Tailgate Kit 10. Release the two sensor bars on the accessory hands-free access unit. ACCESSORY HANDS-FREE ACCESS UNIT 2 SENSOR BARS 4 RETAINING TABS 5 of 8 © 2019 American Honda Motor Co., Inc. – All Rights Reserved. AII13220-10 (1911)
- Page 6 NOTE: Make sure to install the spring nuts as shown. ACCESSORY HANDS-FREE ACCESS UNIT TRAILER HITCH COVER Make sure that the sensor bar is installed. 4 SPRING NUTS 6 of 8 AII13220-10 (1911) © 2019 American Honda Motor Co., Inc. – All Rights Reserved.
- Page 7 25. If necessary, restore the systems back to normal operation as described in the service information. 6 FLANGE BOLTS (Loosely tighten by hand.) 7 of 8 © 2019 American Honda Motor Co., Inc. – All Rights Reserved. AII13220-10 (1911)
- Page 8 TRAILER HITCH BALL MOUNT After the first 600 miles (1,000 km) of towing, have your Honda Dealer check the tightness of the trailer hitch bolts. 8 of 8 © 2019 American Honda Motor Co., Inc. – All Rights Reserved. AII13220-10 (1911)
Need help?
Do you have a question about the 08L92-TGS-100 and is the answer not in the manual?
Questions and answers