Support; Maintaining The Control Panel - Philips TSU9400/93 Starter Manual

Screen
To change the Activation Settings:
• Tap the buttons to toggle between the
different Activation settings:
Pick up sensor: the Control Panel
switches on when it is tilted.
Firm keys: the Control Panel switches on
and/or sends out IR when a firm key is
pressed.
Cursor keys: the Control Panel switches
on and/or sends out IR when one of the
cursor keys is pressed.
To calibrate the touch screen:
1 Tap the Calibrate button.
2 Follow the on screen instructions to tap
the 4 corners of the screen.
The touch screen is calibrated.
Note
The screen is calibrated in the factory.
Do not use this function unless you
experience problems with the touch
screen.

Support

Maintaining the Control Panel

Take care not to damage the touch screen
• Do not drop the Control Panel or subject it to any strong impact.
• Use the stylus enclosed or your finger to tap the touch screen.
Attention Never use an actual pen, pencil or other sharp object on the touch screen to avoid scratching
the touch screen.
Protect the Control Panel from temperature extremes
Keep the Control Panel away from heaters and other heat sources.
The Control Panel is not waterproof
The Control Panel should not be exposed to rain or moisture.
Do not store or use the Control Panel in any location that is extremely damp or wet.
When you have spilled water on the Control Panel, you have to turn it off by switching the Power
switch to "0".
Place the Control Panel in a clean environment to dry.
TSU9400 Starter's Guide
• Tap the '-' and '+' buttons to adjust the
settings.
To exit the Settings pages:
• Press the right firm key labeled Exit.
6