Advertisement
Advertisement
Table of Contents
Related Manuals for Pro-Elec PEL00920
Summary of Contents for Pro-Elec PEL00920
- Page 1 2500W 11 FIN OIL FILLED HEATER Model: PEL00919 and PEL00920...
- Page 2 IMPORTANT SAFETY INFORMATION Please read these instructions carefully before use and retain for future reference. • When using electrical appliances basic safety precautions should always be followed. • Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the appliance to the mains power supply.
- Page 3 PRODUCT OVERVIEW 1. Carry handle 2. Power switches 3. Thermostat control 4. Cord storage 5. Radiator fins 6. Castors ASSEMBLY INSTRUCTIONS • The heater is packaged with the feet unattached. You must attach them before operating the heater. WARNING: Do not operate without feet attached. Only operate the heater in an upright position (feet on the bottom, controls on the top), any other position could create a hazardous situation.
-
Page 4: Specifications
• Wipe the radiator with a soft damp (not wet) cloth. • Do not use any cleaning chemicals such as detergents and abrasives. SPECIFICATIONS Model PEL00919 PEL00920 Rated Voltage 220-240VAC 220-240VAC Frequency 50/60Hz 50/60Hz Rated Power...
Need help?
Do you have a question about the PEL00920 and is the answer not in the manual?
Questions and answers
I have 2 heaters. One is quiet the other is constantly clicking.
The Pro-Elec PEL00920 heater may be clicking constantly due to its thermostat function. The thermostat automatically turns the heater on and off to maintain the set temperature. When the room temperature drops below the set level, the heater switches on, and when it reaches the desired temperature, it switches off, which can cause clicking sounds. Additionally, thermal expansion and contraction of the heater's metal fins as they heat up and cool down can also create clicking noises. If the other heater is quiet, it may be due to differences in thermostat sensitivity, component wear, or operating conditions.
This answer is automatically generated