Matchmaster Digimatch 01MM-DC21A Installation Instructions

01MM-DC21A
UHF/VHF Ch (6-12) (28-40) Digital Compatible Antenna Installation Instructions
Step 1
Snap out corner reflectors
Step 2a
Attach double folded dipole ('G' Unit) to boom using the
6mm (1/4") hex head bolt washers and wing nut. Note:
The 'G' Unit is to be attached to the
bottom side of the boom.
See diagram.
Step 4
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place "F" connector on back to front and twist to
ensure that all braid is flat. See diagram.
(For other cable types
you will need to purchase
the corresponding connector)
by
Step 2
Assemble UHF
Boom to VHF boom
as per diagram
using 5mm screw
and wing nut
provided.
Step 3
Strip coax cable as shown in diagram and feed through
rubber boot seal.
Step 5
Then insert cable into rear of connector and twist connector
clockwise until dielectric is flush with the bottom nut as
in diagram. Ensure that 2-3mm of centre core conductor
protrudes past the nut.
Metal Sheath
Plastic Outer Case
Metal Braid
Dielectric
Knurled Surface
CN3531
Core
Conductor