Kramer WP-20 User Manual page 8

Figure 3 and Figure 4
Figure 3: WP-20 Wall Plate
# Feature
1 REMOTE 5-pin Terminal
Block
2 OPTION 4-way DIP-switch
3 CONTROL 3-pin Terminal
Block
4 AUDIO OUT 3-pin Terminal
Block
5 RS-232 3-pin Terminal Block
6 12V DC Connector
7 Earth Terminal
8 HDBT OUT RJ-45 TP
Connector
WP-20 – Defining WP-20 Wall Plate
define the rear panels of the
Rear Panel
Function
Connect to the remote, contact-closure switches for remote control,
(see Remote Switches Terminal Block
Switches for setting the device behavior, (see
DIP-switch on page 13).
Connect to the serial controller to control the WP-20, (for example, a
PC).
Connect to the unbalanced, stereo audio acceptor, (for example,
amplified speakers).
Connect to the PC to transfer data via RS-232, (for example, a serial
controller for a remote device).
Connect to the supplied power adapter. Not needed on the
there is a PoE provider over HDBaseT.
Connect to the common ground (optional).
Connect to a compatible HDBT TP switcher or receiver (for example,
the TP-780Rxr).
WP-20 and WP-20E.
Figure 4: WP-20E Wall Plate
on page 9).
Kramer Electronics Ltd.
Rear Panel
Setting Configuration
WP-20 if
6