Summary of Contents for Rosinbomb M60
- Page 1 Press with the Best For Use with the ROSINBOMB M60 Owner’s Guide www.rosinbomb.com August 2019...
-
Page 2: Table Of Contents
TABLE OF CONTENTS About Your ROSINBOMB M60 Important Safeguards Operation Advanced Settings Operation Base Settings Operation Frequently Asked Questions Quick Tips Service & Warranty page 2... - Page 3 FDA food grade collection trays for easy clean up at the end of your press cycle. Your M60 press is plug and play out of the box. It is capable of pressing over 6,000 pounds of pressure with one button touch oper- ation.
-
Page 4: Important Safeguards
Choose your surface wisely and ensure its stable and appropriate for pressing. Your ROSINBOMB M60 is plug and play out of the box. Before using the press, remove all packaging components and read the operating instructions. page 4... -
Page 5: Operation
This may take approximately 10 minutes. STEP 2 (Preparation): • Place raw material (flower) in the provided flower ROSINBOMB Press Bags using the ROSINBOMB Bombloader (recommended) or similar tool to tightly pack each bag for press with raw material. -
Page 6: Advanced Settings Operation
You may control the temperature and display of information for each plate. Plate Details: M60 press plates are crafted of aircraft grade aluminum and are powder coated to provide long lasting endurance in press operation. Each plate is three and one quarter inches square and the bottom plate includes a gravity-assisted resin groove that transfers heated resin in liquid form from the press plate surface to the collection tray. - Page 7 ROSINBOMB M60 HCI Advanced Settings Operation (continued) Code Code Description Celsius or Fahrenheit Temperature Display Metric Decimal adjustment for Degree metric .1/1 degree Timer Function ON/OFF (default is OFF) Timing Mode Selection (default is OFF) Once in the menu, a code (see above) will appear representing a setting that may be changed.
-
Page 8: Base Settings Operation
ROSINBOMB M60 HCI Base Settings Operation Code Code Description Heating or Cooling (default is Heating) Differential of Temperature before controller is on Minimum Temperature Limit (default is 1) Maximum Temperature Limit Temperature Set/Calibration Delay Time (default is 1) High Temperature Alarm (default is 0 of Off) -
Page 9: Frequently Asked Questions
What’s the maximum amount of material recommended per pressing? ROSINBOMB recommend a maximum of 15g’s of material in puck form for each press with your M60. We recommend using Bottle Tech style. Do I need any additional equipment to operate my M60? As long as you’re using ROSINBOMB Bags (or another bag... -
Page 10: Quick Tips
QUICK TIPS For the latest in FAQ and tips go to https://www.rosinbomb.com/pages/operationtips. • Make sure to set your M60 heat controllers (both upper and lower plates) to the same temperature for the most efficient heat usage during press. • Allow the plates to pre-heat for approximately 10 minutes to ensure your press is done at the correct temperature. -
Page 11: Service & Warranty
Do not attempt to repair or adjust any mechanical function on your unit. This will void your warranty. Do not use pre-press molds with your ROSINBOMB M60. This could damage your unit and will void your warranty. For comments or questions on your ROSINBOMB M60, contact customer support at: customer.support@rosinbomb.com. - Page 12 www.rosinbomb.com...
Need help?
Do you have a question about the M60 and is the answer not in the manual?
Questions and answers
What type of driving mechanism raises and lowers the press shaft. A load clang sound was heard and a shaking rattle was observed whilst pressing Flowers. the time extended beyond the 2 mins suggested time. We stopped using the press as its quite new, pending your feedback please.
is the 6000 lb force pressure on the plates protected by a load cell safety device to prevent overloading the shaft and entire electrical system including the heater elements