Sanyo FXD-MP690R Service Manual page 9

RADIO OPERATION FOR FXD-MP690R
SWITCHING TO RADIO MODE............................1
Press SOURCE button 1 to select radio mode, the radio mode appears in the display together with the memory
band and frequency.
SELECTING THE FREQUENCY BAND.................2
At radio mode, press BAND/LOUD button 2 shortly to select the desired band.
The reception band will change in the following order:
FM1
RADIO TUNING................................................3
Press the TUN/SEK/TRK
seconds until "MANUAL" appears on the display, the manual tuning mode is selected. If both buttons have not
pressed for several seconds, they will return to seek tuning mode and "AUTO" appeared on the display.
AUTOMATIC MEMORY
STORING & PROGRAM SCANNING.....................4
- Automatic memory storing
Press AS/PS button 4 for several seconds, the radio searches for 6 strongest stations and stores them into
the presets of the currently selected band. While searching, "LOC" appears on the display.
- Program scanning
Press AS/PS button 4 shortly to scan preset station. When the field strength level is more than the threshold
level of stop level, the radio is holding at that preset number for several seconds with release mute, then
searches again.
STORING PRESET STATIONS .................................5
The preset buttons 5 can be used to store 6 stations in each band (FM 1, FM 2, FM 3 and MW, LW) for convenient
access to your favorite stations.
• Programming stations ..... 1. Select the desired band, then tune in the station you want to store in memory.
corresponding preset button number appears. Repeat steps 1. and 2. to program additional stations.
• Quick tuning .................... Select the desired band, then press one of the six preset buttons 5.
FM2 FM3
or button 3 shortly to activate automatic seek function. Press for several
2. Press and hold one of the preset buttons 5 for more than 2 seconds until the
2
5 4
MW LW
8
1 3