Nice ERA MH DC Instructions And Warnings For Installation And Use page 4

GENERAL WARNINGS SAFETY - INSTALLATION - USE (instructions translated from Italian)
ATTENTION Important safety instructions. Follow all instructions as improper installation may cause serious damage
ATTENTION Important safety instructions. It is important for you to comply with these instructions for your own and other people's safety.
Keep these instructions
• Before commencing the installation, check the "Technical characteristics" (in this manual), in particular whether this product is suitable for automating your
guided part. If it is not suitable, DO NOT continue with the installation
• The product cannot be used before it has been commissioned as specified in the chapter on "Testing and commissioning"
ATTENTION According to the most recent European legislation, the implementation of an automation system must comply with the
harmonised standards provided by the Machinery Directive in force, which enables declaration of the presumed conformity of
the automation. Taking this into account, all operations regarding connection to the electricity grid, as well as product testing,
commissioning and maintenance, must be performed exclusively by a qualified and skilled technician!
• Before proceeding with the installation of the product, check that all the materials are in good working order and suited to the intended applications
• This product is not intended to be used by persons (including children) whose physical, sensory or mental capacities are reduced, or who lack the necessary
experience or skill
• Children must not play with the appliance
• Do not allow children to play with the fixed control devices of the product. Keep the remote controls away from children
ATTENTION
In order to avoid any danger from inadvertent resetting of the thermal cut-off device, this appliance must not be powered through an external
switching device, such as a timer, or connected to a supply that is regularly powered or switched off by the circuit
• Provide a disconnection device (not supplied) in the plant's power supply grid, with a contact opening distance permitting complete disconnection under the
conditions dictated by overvoltage category III
• Handle the product with care during installation, taking care to avoid crushing, denting or dropping it, or allowing contact with liquids of any kind. Keep the
product away from sources of heat and naked flames. Failure to observe the above can damage the product, and increase the risk of danger or malfunction.
Should this happen, stop installation immediately and contact Customer Service
• The manufacturer assumes no liability for damage to property, items or persons resulting from non-compliance with the assembly instructions. In such cases
the warranty for material defects is excluded
• The weighted sound pressure level of the emission A is lower than 70 dB(A)
• Cleaning and maintenance to be carried out by the user must not be carried out by unsupervised children
• Before working on the system (maintenance, cleaning), always disconnect the product from the mains power supply
• Check the system periodically, in particular all cables, springs and supports to detect possible
• imbalances, signs of wear or damage. Do not use, if repairs or adjustments are necessary, since installation failure or an incorrectly balanced automation may
cause injury
• There must be at least 0.4 m between the driven parts and any fixed elements
• The wording on the tubular motors can be covered after assembly
• If the cable is damaged, the appliance must be scrapped. The power cable cannot be replaced
1 – English