NEC SL2100 User Manual page 17

No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
SL2100 DT920 (ITK-8LCX) User Guide
Name
Handset
Back Key
Speaker
Dial Keypad
Hold key
Transfer key
Speaker Key (with light)
Cursor Key
Menu Key
Mic Key
Feature Key (with light)
Answer Key (with light)
Recall Key
Programmable Keys
(with light)
Home Key
Soft keys
Used to send/receive voice.
To return to previous window.
To Originate a call with handsfree.
To dial the called party number or feature access code.
To place a call on hold.
Allows the terminal user to transfer established calls to another
terminal, without attendant assistance.
To control the built-in speaker which can be used for handsfree
dialing or monitoring.
To enter a selected item after navigating the menu. This key is
also used to display the shortcut menu for frequently-used
features.
(Note: Only for classic mode)
Volume (UP/DOWN) key
To adjust speaker/receiver volume, and ringer volume while off-
hook. To display the directory (DIR) by pressing the down key
while on-hook.
Right key (Directory)
To access Last Number Redial.
(Note: Only for classic mode)
Left key (Redial)
To display the Call History.
(Note: Only for Classic Mode)
To access the menu of terminal. Only "Phone" and "Settings" icons
function. Directory and History are not supported from this page
and are accessed from the Cursor button.
MIC LED on Microphone is On, LED off Microphone is muted. LED
must be on for handsfree response. MIC key also works for
handset.
To activate features such as terminal setup and to program One-
Touch Speed Calling keys.
To answer the incoming call, when LED on this key is lit.
To finish a call and hear the dial tone to make an another call
(same as Flash Key).
These keys can be programmed as Flexible line key/
Programmable feature key by system administrator.
To display the Utility menu or check the status of programmable
keys press and hold this button.
To check the status of a programmable key, press this button
The feature name is shown at the bottom of the LCD. The
appropriate feature key is displayed on the screen according to the
call handling process.
Function
Issue 1.0
5