Advertisement
3.2.
Trial Operation (After Checking Troubleshooting Guide)
3.2.1.
Assembly
• Confirm if there is no gap between housing light and left by pinching lead wires.
• Confirm that the tool's battery terminal connections are not misshapen, dirty (covered with a thin film), or otherwise in need to
repair.
• Verify that the hanging hook's shape has not been deformed and that it has been attached properly to the housing.
3.2.2.
Operation
• Verify that the top (2) and side (1) light up when the switch is pressed the first time, that the top (2) goes out when the switch is
pressed the second tome, and that the side (1) goes out when the switch is pressed the third time.
• Verify that the LED light angle can be switched among its four settings using the tool's swivel head.
( 0°→ 30°→ 60°→ 90°→ 60°→ 30°→ 0°)
3.2.3.
Integrity
• Shake the tool vertically and horizontally with the switch depressed and verify that there is no change in the brightness of the
LED light.
• Check for the presence of any dirt or foreign matter from the repair process on the outside of the tool.
• With the switch activated, shake the tool back and forth and up and down and verify that its sound does not change excessively.
4
Advertisement
