Hagie NTB Series Manual page 17

Hydrostatic Drive Control Handle
-Typical View
2. Press the Field/Road Button (located on
the Machine Display - Home Page) and
change the machine's drive state to
FIELD mode.
NOTE: The selected drive state will
illuminate.
Field/Road Button
(Located on the Machine Display
- Home Page)
NOTE: The machine's drive state cannot be
changed unless the Hydrostatic Drive
Control Handle is in the NEUTRAL
position.
3. Raise NTB up off ground.
• Press and hold the Transom Switch (located on
the Hydrostatic Drive Control Handle) in the UP
position to raise the entire lift.
OPERATING YOUR NTB
Transom Switch - UP
(Located on the Hydrostatic
Drive Control Handle)
-Typical View
NOTE: Ensure coulters clear the ground.
4. Unfold the NTB by pressing and holding
the corresponding Left and Right Boom/
NTB Switches (located on the Hydro-
static Drive Control Handle) in the OUT
position.
Left and Right Boom/NTB Switches
(Located on the Hydrostatic
Drive Control Handle)
-Typical View
SECTION 3 –
3-3