Bonnet
CAUTION
l
Note that the support bar may disengage the
bonnet if the open bonnet is lifted by a
strong wind.
l
After inserting the support bar into the slot,
make sure the bar supports the bonnet se-
curely from falling down on to your head or
body.
To close
1. Unlatch the support bar and clip it in its
holder.
2. Slowly lower the bonnet to a position
about 20 cm above the closed position,
then let it drop.
10
3. Make sure the bonnet is securely locked
by softly lifting the centre of the bonnet.
10-04
Maintenance
CAUTION
l
Be careful that hands or fingers are not trap-
ped when closing the bonnet.
l
Before driving, make sure that the bonnet is
securely locked. An incompletely locked
bonnet can suddenly open while driving.
This can be extremely dangerous.
NOTE
l
If this does not close the bonnet, release it
from a slightly higher position.
l
Do not press down the bonnet hard with a
hand as it may damage the bonnet.
OGAE19E1
NOTE
l
For vehicles equipped with the security
alarm system, if you drive with the bonnet
left open, warning display is displayed on
the information screen in the multi-informa-
tion display.
Type 1
Type 2
Need help?
Do you have a question about the ASX 2019 and is the answer not in the manual?
Questions and answers
Как восстановить работу ручного замка от ключа на водительской двери автомобиля MITSUBISHI - 2019г.
To restore the manual lock operation from the key on the driver's door of a Mitsubishi ASX 2019, you may need to deactivate the Dead Lock System. This system prevents unlocking the doors using the inside lock knobs when activated. These functions are not activated when the vehicle is shipped from the factory, but they can be activated or deactivated by contacting a Mitsubishi Motors Authorized Service Point.
This answer is automatically generated