Installing The Dxl8000; Unpacking The Dxl8000; Preparing To Install The Dxl8000; Operating In Safety - Vislink DXL8000 User And Technical Manual

Installing the DXL8000

2
This chapter describes how to unpack and install your DXL8000 Short-Haul Microwave System.
CAUTION

2.1 Unpacking the DXL8000

Carefully unpack your new equipment to avoid accidental damage.
: DO NOT discard the container or packing material until you have inspected the
NOTE
equipment and are sure there is no shipping damage. The container and
packing must be available in case you need to file a damage claim with the
shipping carrier.
• Inspect the equipment for damage and that it is clean and dry.
• Inspect the cables, connectors, switches, and displays to ensure that they are not
broken, damaged or loose.
If you discover damage after unpacking the system, report the damage as follows:
• Immediately file a claim with the shipping carrier.
• Forward a copy of the damage report to Vislink Customer Service.
• Contact Customer Service to determine the disposition of the equipment. See
Section 1.3, About the Outdoor

2.2 Preparing to Install the DXL8000

The following sections describe the things you should consider before installing the DXL8000.

2.2.1 Operating in Safety

CAUTION
DXL8000 User and Technical Manual
If you modify the product without authorization from MRC, you
will void the warranty.
Unit.
Ensure that the power being supplied matches the power
required by the equipment. You can find power ratings for
equipment on a rating plate, usually on the rear panel.
Ensure that the electrical supply is protected by over-current
protection devices as required by the applicable electrical
codes. If necessary, consult a licensed electrician.
Installing the DXL8000 2-1