Sealey SA613 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used
according to these instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND
CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are
adhered to when using this equipment.
 WARNING! Disconnect hammer from the air supply before changing accessories, servicing or
performing any maintenance.
 Keep the hammer clean and maintain it in good condition (use an authorised service agent).
 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
 Keep the work area clean and uncluttered. Ensure that there is adequate lighting.
 Ensure chisels are correctly rated for the job. DO NOT use damaged or suspect chisels.
 WARNING! Wear approved safety eye or face protection, ear defenders and, if dust is
generated, respiratory protection.
 Keep hands and body clear of the work when operating the hammer.
 Maintain correct balance and footing. Ensure that the floor is not slippery and wear non-slip
shoes.
 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain
and/or tie back long hair.
 Keep children and unauthorised persons away from the work area.
 Secure unstable workpiece with a clamp, vice or other adequate holding device.
 Avoid unintentional starting.
 WARNING! Ensure that the correct air pressure is maintained and not exceeded.
 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before use and
ensure all connections are secure.
 DO NOT use the hammer for a task it is not designed to perform.
 DO NOT operate the hammer if any parts are damaged or missing as this may cause failure
and/or personal injury.
 WARNING! DO NOT chisel into any materials containing asbestos.
 WARNING! DO NOT chisel into any workpiece where there is a risk of a live electrical power
source.
 DO NOT switch the hammer on whilst the chisel is in contact with the workpiece.
 DO NOT carry the by the hose, or yank the hose from the air supply.
 DO NOT hold the workpiece by hand. Use clamps or a vice (available from your Sealey dealer)
to secure the workpiece.
 DO NOT allow untrained persons to operate the hammer.
 DO NOT operate the hammer when you are tired or under the influence of alcohol, drugs or
intoxicating medication.
 DO NOT use hammer where there is flammable liquid, solid or gas such as paint solvent, including
waste wiping or cleaning rags etc.
 DO NOT leave the hammer operating unattended.
 DO NOT carry the hammer with your finger on the trigger.
 DO NOT direct air from the air hose at yourself or others.
 When work is complete ensure that the air supply is turned off.
 When not in use disconnect from the air supply and store in a safe, dry, childproof area.
INSTRUCTIONS FOR:
AIR HAMMER KIT COMPOSITE PREMIER
MEDIUM STROKE LOW VIBRATION
MODEL N
Original Language Version
SA613
:
O
SA613 Issue: 1 - 07/09/11