Table of Contents
Advertisement
Quick Links
Digital Meter for the measurement of Temperature, salinity and specific gravity
Short instructions:
ON
OFF
: Is used to turn the power on and off.
Once turned on, the present Temperature is displayed
in the LCD Display window.
MODE
: The default mode is the Temperature measurement.
Press to cycle to Salinity measurement (ppt), press again
to cycle to Specific Gravity measurement.
HOLD
(TEST)
: Is used to "lock" the measurement value during a test.
After viewing measurement, press again to clear LCD
screen and start another test.
°C
Indicates the Temperature of sample.
ppt
Indicates the Salinity contained within the sample.
(0.000)
Indicates the Specific Gravity within the sample.
HOLD
Is displayed in the LCD display window when the measured value is held.
Appears when the measurement is not within the normal testing range.
Temp. range (0°C 100°C)
ERROR
Salinity Range (5 40 ppt)
Specific Gravity (1.000 1.032)
Is displayed when replacement of battery is needed.
Operation Manual
Marin Control Digital
in saltwater aquariums.
Sample
1 cm
For more accurate
measurement
Advertisement
Table of Contents
Related Manuals for Aqua Medic Marin Control Digital
Summary of Contents for Aqua Medic Marin Control Digital
- Page 1 Operation Manual Marin Control Digital Digital Meter for the measurement of Temperature, salinity and specific gravity in saltwater aquariums. Short instructions: : Is used to turn the power on and off. Once turned on, the present Temperature is displayed in the LCD Display window.
- Page 2 1.1 Precaution before use Please read the entire operation manual before using this Marin Control Digital. Failure to read this manual prior to usage may result in equipment damage and will void warranty. Caution: Please observe the procedures and methods specified in the operation manual to ensure precision, accuracy and reliable measurements and user safety.
- Page 3 1.3 Cautions on measuring Please wash the sensors with a neutral detergent using a soft cloth or sponge before and after use for the most reliable test results. Dry off sensors with a clean cloth and always keep dry while not in use. Make sure sensors do not contact any of the walls of the aquarium or sump while in measurement mode.
- Page 4 Measurement Selection (MODE) button When the power is turned on, the default mode is the Temperature measurement. Press to cycle to Salinity measurement (ppt), press again to cycle to Specific Gravity measurement. Hold (TEST) button It is used to “lock” the measurement value during a test. After viewing measurement, press again to clear LCD screen and start another test.
- Page 5 6. Wait 10 seconds for the Specific Gravity to stabilize and read results. 7. You may press the (“HOLD”) button at anytime to “lock” the measurement so you do not have to keep the probe submerged in the water to read the measurement value. Press again to “unlock” and test again. 8.
Need help?
Do you have a question about the Marin Control Digital and is the answer not in the manual?
Questions and answers